Teach you how to clean the air conditioner

The sultry summer is here again. Under the high temperature of forty degrees, only the air conditioner can save your dog's life. But do you know the old air conditioner in your house has not been used for a long time? How much dirt is hidden in it?

However, if someone asks you to come and help you wash the air conditioner, it will cost you one or two hundred. Now that everyone is so poor, you can save a little bit. We will teach you how to wash the air conditioner yourself.

Simple cleaning of wall-mounted machine:

1. Open the cover and remove the air conditioner filter for cleaning

2. Use air conditioner cleaner to clean the evaporator blade

Deep cleaning of air conditioner:

The main structure of the heat sink designed by the air conditioner is made of metal, and generally does not fail. The part of the fan is to send cold air to the house through the motor + fan blade. Pay special attention to the intelligent control circuit board, which needs to be protected from water.

Let’s take a look at the protagonist we are going to wash today: a wall-mounted air conditioner located in the bedroom.

Step 1: Disconnect the power

Needless to say, safety first

Part 2: Open the inner cover

Pull out the air conditioner filter, this process is very simple and no picture is left

Step 3: Remove the shell

In particular, pay attention to the three screws below.

There is a remote control display cable on the right side connected to the host, and the cover screw of the cable should also be removed

There are three buckles on the top of the hook, we break him apart

Press your finger and it opens

Remove the case, but don’t tear the screen link

In this way, the shell of the air conditioner was removed by us

Step 4: Remove the windshield

The windshield is also super dirty, remove it and wash it

Pull down to let the buckle off

The only thing to note is that the side of the wind deflector needs to be closed to the gap before taking it out, otherwise the small dots in the red circle will break.

The shell was completely removed by us, so quickly wash it

Step 5: Remove the drain

The purpose of removing the sink is to make it easier to clean the fan blades

The sink is placed on the host, you need to hold the sides of the sink with both hands, and remove it as shown in the figure

Take off one side and connect the drain to the other side, you don’t need to take it down, it can be cleaned

Step 6: Clean the fan blades

It is not recommended to remove the fan blade, because it is difficult to disassemble, and it is difficult to install it again after disassembly.

First brush the fan blade with a brush

After washing the fan blades, the drain trough should be installed back as is, and then pick up the dirt for the next cleaning

The evaporator blade is dense and fragile, hiding a lot of dust bacteria, it is best to use special detergent for cleaning

This kind of cleaning detergent is very easy to buy on Taobao, I won't say much.

Use a brush to clean the fan blades

Let it sit for about 15 minutes until the bubbles disappear, during which time you can clean the shell. Then reload

The steps will not be described in detail, you can install it as you want. Forget about the steps and look upside down.

After installation, turn on the machine to refrigerate and confirm whether it can be used normally. The replacement is to let the moisture in the air meet the condensed liquid to self-clean the stains on the evaporator blades.

If the air conditioner has a built-in cleaning function, you can start the cleaning program at this time

At this time, you can see that the water allowed by the drain is black. Fortunately, the air conditioner was clean.

Finally, clean the walls and floors. The entire cleaning process is completed.

If your friends don’t want to do it yourself, you can find me directly. I am professional.